Speed Searchв Control V 15.0.2 Page

Typically set between 100% and 150% of the motor's rated current. This determines how much "effort" the drive uses to find the frequency.

Decide if you want it to trigger automatically after a power loss or every time a "Run" command is given. 2. Configure Current and Timing

Set b3-01 (Speed Search Selection) to 1 (Enabled) . Speed searchВ Control v 15.0.2

To ensure the drive catches the motor smoothly without tripping an overcurrent fault, adjust the search sensitivity:

Look for a steady LED indicator or a software status bit that confirms the drive is in "Speed Search" mode during startup. Typically set between 100% and 150% of the

To prepare or enable the feature in a control system (such as Yaskawa or similar VFD controllers ), follow these general configuration steps: 1. Enable the Speed Search Function

Locate the primary activation parameter in your control interface. To prepare or enable the feature in a

If you are using a specific software suite (like or Alta Control ) where "v 15.0.2" refers to a firmware version, check the Cisco Bug Search Tool or the Alta Release Notes to see if "Speed Search" refers to a new UI search optimization or performance feature.