Statiдќko: Usmjeravanje.pkt

: Using commands like show ip route to check the routing table and ping to test connectivity.

: To configure a static route on a Cisco router, the general command used is: Router(config)# ip route [destination_network] [subnet_mask] [next_hop_address_or_exit_interface] . Typical Lab Exercise Tasks ( .pkt file)

: Unlike dynamic routing protocols, information about destination paths is entered into the router's routing table manually. StatiДЌko usmjeravanje.pkt

: Routers use these tables to forward packets between different networks.

: Connecting routers and PCs using appropriate cables (e.g., Serial or Ethernet). : Using commands like show ip route to

: Entering specific ip route commands so that a computer on one network can "ping" a computer on a distant network.

A standard lab exercise for this topic usually involves the following steps: : Routers use these tables to forward packets

: Assigning IP addresses and subnet masks to all interfaces.